When the water coming from the faucets at home doesn’t smell good, there is most likely a problem with your water heater. There are a couple of various causes of smelly water, yet the main reason is bacteria. In the event that bacteria is coming into the water, a smell may develop. Well water is generally to blame for this transpiring. Even so, there are some methods a Lancaster PA homeowner can take to prevent bacteria from expanding in their water and to eliminate existing bacteria and odors.

Protecting Against Water Heater Bacteria Growth

The easiest way to stop bacteria from growing and resulting in bad tastes and smells throughout one’s property, is to make sure the temp is fixed at 140 degrees or greater on one’s hot water heater. At this climate bacteria can’t expand and will die. In case your water heater temperature is set any lower than this, bacteria will not only exist but will multiply.

According to Soquel Creek Water District, “The smell is the result of four factors that must all be present for the odor to develop. These factors include:

  • A high concentration of sulfate in the raw water
  • Sulfate reducing bacteria, non-toxic to humans (sulfate is reduced to a sulfide state by the bacteria)
  • Little or no dissolved oxygen in the water
  • Hydrogen (a component of water which may be present due to water conditions reacting with the anode)”  Read more here…

Removing Hot Water Heater BacteriaLancaster PA Water Heater Odors

In order to eliminate present bacteria and smells, one should apply chemicals to remove it. Chlorine bleach is the most efficient and comprehensive chemical cleaner to use. If you are making an attempt to clean out the water and get rid of the bacteria by using bleach yourself, you should understand the complete technique of to do so. First, the electric or gas going to the water heater must be turned off. After that the cold water supply ought to be switched off. Then, you will need to turn on one of the hot water faucets inside of the house. This allows air in the tank. Utilizing a garden hose, empty the water out of the water heater and close the drain valve once all of the water has been drained. Next, it’s time to pour in the bleach. One will need five ounces of chlorine bleach for each gallon of water the tank holds. Unscrew the flexible cold water hose and pour the bleach into the opening. In the event the cold water hose is not flexible, it might be a good idea to get in touch with a professional. Connect the water line again and fill up the tank with water. It is necessary to turn off the hot water faucet in the home when all of the air is out of the pipe. It’s also crucial to run each one of the taps which use hot water throughout the house until you are able to smell the bleach. The bacteria that is inside the water heater could also be in pipes and taps so you will have to kill the bacteria in those areas as well. Allow the bleach water stay inside the tank and inside the piping for around 3 hours not having utilizing any hot water. After that one more flush is due. When the tank is drained once more, do not put in more bleach but fill it up with water and give it time to sit inside the tank and in the piping for no less than thirty minutes. Finally, drain the water again and refill the tank with water. Allow all of the hot water appliances in the house drain until you can not smell bleach. Either turn the power on again or relight the pilot and you should be good to go!

For any concerns about water smell, flushing a water heater, Lancaster water heater repairs, or other water heater problems, give us a call!